What’s Behind Door #1?

After a lot of very cold, shop-prohibitive weather, the holidays, and some general laziness, I finished one of the Kasumi-Gumi hip board shoji panels. My original intent was to build two, and then a basic display frame that would allow the panels to slide as they were meant to. But I had some technical issues and had to cannabalize some of the pieces from the second door to finish the first one. Cutting all those half-lap joints by hand, particularly of the 4mm wide kumiko proved to be more challenging that I foresaw. So, good practice but I’ll have to cut some more kumiko for the second panel before I can finish the original goal.

Here’s the primary vertical and horizontal kumiko fit together and set lightly on top of the frame to get a sense of where everything goes and whether my initial measurements and cuts were accurate.


A detail of the various Kasumi (mist) kumiko after assembly but prior to attaching the shoji paper. Each of the free-end kumiko are chamfered on the top and sides. Don’t look too close or you might see some warts in the joinery:-)


After a long evening of sawing, chopping, sawing and chopping some more.


Door #1 glued and assembled.


Shoji paper attached to the back.


Time for some surgery here: I made a very simple walnut pull, using a gouge to rough out the indentation-was going for a rustic, hand-hewn look. Not perfect but kind of interesting.


And the pull mortise cleaned out.


Fitting the pull to the mortise.


And tapped down. Just need to plane the excess flush with the stile.


And the finished piece. I’m pretty happy with it. Definitely some gaps, especially where the kasumi kumiko meet the tsukeko. This is really just a result of patience or lack there of. The more time I spend really focusing on cutting the joinery, the better it is.



8 thoughts on “What’s Behind Door #1?

    • Thanks, Brian. Lots of room for improvement on the joinery details but nice to get this far. ~Bobby

Comments are closed.